A gaming room has two noise problems at once. Sound comes in from outside — traffic, neighbors, a busy household — and sound bounces around inside, because bare walls and hard floors reflect every click and callout. Curtains attack the first problem at the window and the door, and help with the second by adding soft, heavy fabric to a reflective room. They are not a replacement for wall-mounted acoustic panels, which treat echo inside the room; curtains are window and door panels sold by size and header type, hung on rods, and judged here on how much sound they block.
- How to choose soundproof curtains for a gaming room
- 1. RYB HOME Soundproof Curtains 84 Inches – 3 Layers
- 2. NICETOWN Sound Barrier 100% Blackout Divider Curtains
- 3. Moondream DecibelControl 3-in-1 Soundproof Curtain MC634
- 4. KGORGE 4-in-1 Soundproof Blackout Curtains
- 5. KOUFALL Extra Wide Linen Soundproof Blackout Curtains
- Quick comparison
- FAQ
- Conclusion
No curtain makes a room silent. A good soundproof curtain cuts mid and high frequencies — voices, keyboard clatter, television bleed — and takes the edge off street noise. The five panels below all use layered construction with a felt or filter layer doing the heavy lifting. Panel counts and sizes are stated per panel, because the per-pair versus per-panel distinction is the easiest way to buy the wrong amount of fabric.
As an Amazon Associate, we earn from qualifying purchases.
How to choose soundproof curtains for a gaming room
Layers matter more than brand names. A single layer of blackout fabric blocks light but does little for sound. The curtains that actually dampen noise add mass: a triple-weave face, a detachable felt liner in the middle, and sometimes a melt-blown filter cloth. The felt liner is the key sound layer, and it usually detaches so the outer panels can be washed.
Weigh the coverage, not just the panel. Sound reduction comes from mass and coverage. A panel that barely spans the window leaves gaps at the edges where noise walks in. Measure the rod, then buy flat fabric 1.5 to 2 times the rod width so the curtain gathers into full folds. Always check whether the listing sells one panel or a pair, and whether the stated width is per panel or combined.
Match the header to the rod. Grommets slide easily and suit rods up to about 1.6 inches in diameter. A rod pocket seals the top gap better, which helps where sound leaks over the rod, but it slides less freely. Tab tops hang from fabric loops and suit decorative rods. Pick the header that fits the rod already on the wall.
Read decibel claims with care. Makers test their curtains under different conditions, so a decibel figure from one brand does not compare directly with a figure from another. A 10 dB reduction is a large one — as a rule of thumb, it sounds roughly half as loud — but it comes from a lab test on one fabric, not a guarantee for a whole room. Treat maker figures as a way to rank curtains within one brand.
Blackout and soundproofing overlap but are not the same job. Blackout fabric blocks light; soundproofing needs mass and layers. Many soundproof curtains are also 100% blackout, but a blackout curtain without a felt or filter layer will not do much for noise. If a listing leads with light blocking and never names a sound layer, it is a blackout curtain, not a soundproof one.
Mind the rod. Felt-lined curtains are heavy — a two-panel set can weigh over 5 pounds — and a light tension rod will sag or pull out of the wall. Use a sturdy rod with a center support for wide spans.
1. RYB HOME Soundproof Curtains 84 Inches – 3 Layers
The RYB HOME set is the most straightforward pick here: two panels, each 52 inches wide and 84 inches long, built from triple-weave blackout fabric with a detachable felt liner in the middle. The felt liner absorbs sound that the outer blackout layers alone would let through, and the set blocks 100% of light at the same time. Grommets make the panels easy to slide, and the liner comes out before washing. Each panel is handmade, so RYB HOME notes sizes can vary by 2 to 3 centimeters. For a standard window, this is the set to start with: a felt middle layer, a familiar size, and no unusual hardware.
Specs
- Size: 2 panels, each 52 x 84 in (104 in combined)
- Layers: 3 — triple-weave blackout face, detachable felt liner, blackout back
- Header: Grommet
- Light blocking: 100% blackout
- Care: Machine washable; remove the felt liner first
- Colorway: Gray
- ASIN: B083467LR8
2. NICETOWN Sound Barrier 100% Blackout Divider Curtains
NICETOWN’s Sound Barrier set is the heavyweight here, built for rooms where noise and light both need to go. Two panels, each 52 by 84 inches, combine two triple-weave layers with a detachable felt liner, and the listing states the set absorbs 2.5 times more sound than standard curtains. The 1.6-inch grommets fit standard rods, and the white panels block 100% of sunlight. The set weighs 5.5 pounds, so a sturdy rod with a center support is part of the purchase. That weight is also what makes the set work: the felt liner plus the dense triple weave give the panels real mass, and mass is what stops sound. For a street-facing gaming room, this is the most aggressive noise-first option here. Confirm the live offer before ordering.
Specs
- Size: 2 panels, each 52 x 84 in (104 in combined)
- Layers: 3 — two triple-weave layers plus detachable felt liner
- Header: 1.6-in grommets
- Light blocking: 100% blackout
- Weight: 5.5 lb per set
- Sound claim: Absorbs 2.5 times more sound than standard curtains, per the listing
- Colorway: White
- ASIN: B081R2FC5G
3. Moondream DecibelControl 3-in-1 Soundproof Curtain MC634
Moondream is the only pick here with a published lab test behind its noise figure, and that is why it earns a place despite being sold as a single panel. The MC634 is one panel, 55 by 84 inches, built from three layers — blackout fabric, thermal lining, and a cotton-effect face — under a patented 3-in-1 design. A Kietudes test run in line with EN ISO 10052 measured noise reduction of up to 10 dB for this model, a serious figure for a curtain. One panel covers a standard window, but a wide window or a pair of windows needs two. The curtain is dry-clean only and hangs on 1.6-inch grommets. The velvet MC228 variant carries a different test figure — the 10 dB figure belongs to the MC634. Availability runs through third-party sellers, so confirm the live offer before ordering.
Specs
- Size: ONE panel, 55 x 84 in (not a pair)
- Layers: 3-in-1 — blackout fabric, thermal lining, cotton-effect face
- Header: 1.6-in grommets
- Light blocking: 100% blackout
- Noise reduction: Up to 10 dB, per Kietudes test in line with EN ISO 10052
- Care: Dry-clean only
- Colorway: Beige Eggshell MC634
- ASIN: B018UH2YPS
4. KGORGE 4-in-1 Soundproof Blackout Curtains
KGORGE adds a fourth layer to the usual formula, and that layer does a second job. Two panels, each 52 by 84 inches, combine a detachable felt liner with a melt-blown filter cloth middle, so the set is sold as soundproof, blackout, thermal, and anti-dust in one. The maker states the curtains absorb sound 2 to 3 times better than standard curtains, and the melt-blown layer targets dust and airborne particles, which matters in a room full of PC intakes. The felt liner detaches for washing, and the panels are machine washable once it is out. Like the other felt-lined sets here, the fabric is heavy, so the rod needs a center support on wide spans. For a gaming room that also needs dust control — a ground-floor room, a room near a busy road, a room with pets — the extra filter layer is a genuine difference.
Specs
- Size: 2 panels, each 52 x 84 in (104 in combined)
- Layers: 4 — detachable felt liner plus melt-blown filter cloth middle
- Header: Grommet
- Light blocking: 100% blackout
- Sound claim: 2 to 3 times better sound absorption than standard curtains, per the maker
- Extra: Anti-dust melt-blown layer; white backside
- Care: Machine washable; remove the felt liner first
- ASIN: B0BV291XJM
5. KOUFALL Extra Wide Linen Soundproof Blackout Curtains
The KOUFALL set solves a different problem: width. Two panels, each 70 by 84 inches, give 140 inches of flat fabric, which covers a sliding door or a wide picture window with one set. The face has a linen texture, the backing blocks 100% of sunlight, and the maker states about 50% noise reduction. The header is a rod pocket with a tab top — not grommets — and the rod pocket seals the top of the curtain against the rod, closing the gap where sound slips over. The listing does not name an inner sound layer the way the felt-lined picks do, so this set is here for its width and mass rather than a named felt core. Do not confuse it with the separate 72 by 84 microfiber thermal line from the same brand, which uses grommets and a different blackout figure.
Specs
- Size: 2 panels, each 70 x 84 in (140 in combined)
- Face: Linen-textured
- Header: Rod pocket + tab top (not grommet)
- Light blocking: 100% blackout
- Sound claim: About 50% noise reduction, per the maker
- Colors: Cream Beige, Navy
- ASIN: B0FGWWV4FW
Quick comparison
| Curtain | Panels | Size per panel | Layers | Header |
|---|---|---|---|---|
| RYB HOME 3 Layers | 2 | 52 x 84 in | 3, detachable felt | Grommet |
| NICETOWN Sound Barrier | 2 | 52 x 84 in | 3, detachable felt | 1.6-in grommets |
| Moondream MC634 | 1 | 55 x 84 in | 3-in-1, lab-tested | 1.6-in grommets |
| KGORGE 4-in-1 | 2 | 52 x 84 in | 4, felt + melt-blown | Grommet |
| KOUFALL Extra Wide Linen | 2 | 70 x 84 in | Lined, linen face | Rod pocket + tab top |
FAQ
Do soundproof curtains actually block noise?
They reduce noise; they do not eliminate it. A layered curtain with a felt liner cuts mid and high frequencies — voices, keyboard clatter, television sound — softens street noise, and dampens echo inside the room. Low-frequency bass passes through fabric almost untouched, and gaps around the edges let sound in no matter how heavy the panel is. Expect a quieter room, not a silent one, and a sealed window and solid door help further.
How wide should soundproof curtains be for a gaming room window?
Buy flat fabric 1.5 to 2 times the width of the rod so the curtain gathers into full folds. A 52-inch panel pair gives 104 inches of flat fabric, which suits rods up to about 60 inches wide; a 70-inch panel pair gives 140 inches and covers sliding doors and wide windows. Always check whether the listing sells one panel or a pair, and whether the stated width is per panel or combined.
Are soundproof curtains the same as blackout curtains?
No, though the two overlap. Blackout curtains are judged on light blocking; soundproof curtains are judged on mass and layers — a felt liner, a filter cloth, or a lab-tested construction. Many soundproof curtains are also 100% blackout, but a blackout curtain without a named sound layer will not do much for noise. If the listing never names a felt liner, a filter layer, or a test figure, treat it as a blackout curtain.
Can I hang soundproof curtains on a standard curtain rod?
Usually yes, if the rod is sturdy. Felt-lined sets are heavy — the NICETOWN set here weighs 5.5 pounds — so use a rod rated for the weight, add a center support on spans over about 48 inches, and check that the grommets fit the rod diameter. Rod-pocket curtains need a rod that fits the pocket. A light tension rod is not enough for these panels.
Conclusion
For most gaming room windows, the RYB HOME 3-layer set is the straightforward choice: a felt middle layer, a standard 52 by 84 size, and full blackout in one pair. The NICETOWN Sound Barrier set is the pick when noise and light both need maximum blocking. The Moondream MC634 is the only pick with a published lab test, and it suits buyers who want a measured figure rather than a maker claim — remember it sells as one panel. The KGORGE 4-in-1 adds a dust-filter layer for rooms that need it, and the KOUFALL Extra Wide set covers sliding doors and wide windows with a single pair. Measure the rod, confirm the panel count on the live listing, and hang the curtains on a rod strong enough for the weight.




